主题: 【讨论】愿意解答焊工工作的问题
查看单个帖子
旧 May 30th, 2006, 19:00     #29
shqchen
大水瀑
级别:5 | 在线时长:57小时 | 升级还需:3小时
 
注册日期: Jul 2004
帖子: 85
shqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud ofshqchen has much to be proud of
发送 Skype™ 消息给 shqchen
默认
引用:
作者: 云淡天高
这不好说,看多厚,接口方式,还有个人习惯.我用MIG:45,200.焊接1MM厚的.要快,不能停,否则易 BURN THROUGH.你再调低些试试.另外,焊机一般有说明书,你打开机器就会看到,上面会有根据不同材料,厚度等建议使用的参数,你再根据自己习惯稍微调整一下即可.
强顶!照这样的形势,这里的懂行的大侠这么热心,这个论题可以长期深入讨论下去!
shqchen 当前离线  
回复时引用此帖