Aug 14th, 2008, 10:50 | 只看该作者 #36 |
V V I P
注册日期: Aug 2004
帖子: 3,432
积分:26
精华:8
声望: 36952378
|
别不信我啊,我都是这么干的。 给你搜篇文章看,老外也差不多 If you are certain that you have a stud wall in the area you will be attaching your ledger to then finding the studs shouldn't be too difficult, even through stucco. It will take a little measuring and common sense. You will need a drill with a small masonry bit, a measuring tape and a hammer. Most framing is either 16" on center or 24" on center. Measuring from the corner of the foundation, try tapping on the wall with a hammer at 16" and see if it sounds solid or hollow. If it sounds hollow try 24" from the corner. When you find a spot that sounds solid drill a hole there and see if you hit a stud, if not you can move an inch each direction and drill another hole. You should find the stud with one of these holes. You can also purchase a stud sensor to help find the stud(from any home improvement store). It will take one that will work through stucco. It will say on the package. Anyhow, once you locate the first stud you need to keep going and make sure you verify the stud layout. Mark each stud as you go and thats it. You can fill all the test holes you have drilled with a silicone caulking. Make sure you do all of this in an area that will be covered by the ledger board http://en.allexperts.com/q/Building-...k-ledger-1.htm |
|
Aug 14th, 2008, 14:49 | 只看该作者 #40 |
华枫管理员
注册日期: Jul 2004
帖子: 27,175
声望: 5781998
|
多论多的deck都这么小? 更象balcony
|
http://i42.tinypic.com/eqdv2x.gif http://img517.imageshack.us/img517/1...1123801530.gif 做爱做的事,交配交的人.穿别人的鞋,走自己的路,让他们找去吧! |
|
|