Apr 15th, 2008, 20:04 | #1 |
Senior Member
注册日期: Apr 2008
帖子: 507
|
请问有没有无线接入的router?
RT
|
|
Apr 15th, 2008, 23:52 | #2 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
|
|
Apr 15th, 2008, 23:53 | #3 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
|
|
Apr 16th, 2008, 20:13 | #4 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
|
|
Apr 16th, 2008, 20:35 | #5 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
|
|
Apr 18th, 2008, 21:31 | #6 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
|
|
Apr 18th, 2008, 23:14 | #7 |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
How To Flash the WRT54G v8 / WRT54GS v7 1. configure your local lan ethernet address to 192.168.1.100 and connect your local ethernet to your WRT54Gv8/GSv7 on one of the 4 switch ports 2. plugoff the power cord from the WRT54G v8/GSv7 3. push the reset button while replugin the power cord and hold the button for about 20 seconds 4. open your browser and open http://192.168.1.1 5. use the firware upgrade dialog to flash vxworkskillerGv8.bin / vxworkskillerGSv7.bin 6. after the dialog is shown that you need to plugoff the power cord, remove the power cord and replug it in 7. wait for about 1 - 2 minutes 8. plugoff the power cord again and replug it in. 9. enter "tftp -i 192.168.1.1 put dd-wrt.v24_micro_wrt54gv8.bin" on your local windows console and press enter (for linux, tftp 192.168.1.1; mode octet;put dd-wrt.v24_micro_wrt54gv8.bin) 10. the file will now be transfered to your router and be flashed. after this is done, dd-wrt will automaticly boot and you can reach your router at http://192.168.1.1 ---------------------------------------------------- 遭糕,把router搞坏了,第一步没做改192.168.1.100,router不能用了,怎么办? 救救我 |
|
Apr 19th, 2008, 10:54 | #8 | |
Senior Member
注册日期: Apr 2008
帖子: 507
声望: 0
|
引用:
不知怎么接入无线信号,输入密码?要设置提供无线网的router吗? 此帖于 Apr 19th, 2008 11:14 被 la2 编辑。 |
|
|